Filter
Top Products
D-Link DWS-1008 CLI Manual 81
clear ntp server
Removes an NTP server from a switch configuration.
Syntax: clear ntp server {ip-addr | all}
ip-addr IP address of the server to remove, in dotted decimal notation.
all Removes all NTP servers from the configuration.
Defaults: None.
Access: Enabled.
Examples: The following command removes NTP server 192.168.40.240 from a switch
configuration:
DWS-1008# clear ntp server 192.168.40.240
success: change accepted.
See Also:
• clear ntp update-interval
• set ntp
• set ntp server
• set ntp update-interval
• show ntp
clear ntp update-interval
Resets the NTP update interval to the default value.
Syntax: clear ntp update-interval
Defaults: The default NTP update interval is 64 seconds.
Access: Enabled.
Examples: To reset the NTP interval to the default value, type the following command:
DWS-1008# clear ntp update-interval
success: change accepted.
See Also:
• clear ntp server
• set ntp
• set ntp server
• set ntp update-interval
• show ntp