Filter
Top Products
D-Link DWS-1008 CLI Manual 336
name
rate
Defaults: The default RF Auto-Tuning channel holddown is 900 seconds.
Access: Enabled.
Usage: The channel holddown applies even if RF anomalies occur that normally cause an
immediate channel change.
Examples: The following command changes the channel holddown for radios in radio profile rp2
to 600 seconds:
DWS-1008# set radio-profile rp2 auto-tune channel-holddown 600
success: change accepted.
See Also:
• set radio-profile auto-tune channel-config
• set radio-profile auto-tune channel-interval
• set radio-profile auto-tune channel-lockdown
• show radio-profile
Radio profile name.
Minimum number of seconds a radio must remain on its current channel setting
before RF Auto-Tuning is allowed to change the channel. You can specify from 0 to
65535 seconds.
set radio-profile auto-tune channel-interval
Sets the interval at which RF Auto-Tuning decides whether to change the channels on radios in
a radio profile. At the end of each interval, MSS processes the results of the RF scans performed
during the previous interval, and changes radio channels if needed.
Syntax: set radio-profile name auto-tune channel-interval seconds
name
seconds
Defaults: The default channel interval is 3600 seconds (one hour).
Access: Enabled.
Usage: D-Link recommends that you use an interval of at least 300 seconds (5 minutes). RF
Auto-Tuning can change a radio’s channel before the channel interval expires in response to RF
anomalies. Even in this case, channel changes cannot occur more frequently than the channel
holddown interval.
Radio profile name.
Number of seconds RF Auto-Tuning waits before changing radio channels to
adjust to RF changes, if needed. You can specify from 0 to 65535 seconds.