Filter
Top Products
D-Link DWS-1008 CLI Manual 159
show ip https
Displays information about the HTTPS management port.
Syntax: show ip https
Defaults: None.
Access: All.
Examples: The following command shows the status and port number for the HTTPS management
interface to the switch:
DWS-1008> show ip https
HTTPS is enabled
HTTPS is set to use port 443
Last 10 Connections:
IP Address Last Connected Time Ago (s)
-----------------------------------------------------------------------------
10.10.10.56 2003/05/09 15:51:26 pst 349
The table below describes the fields in this display.
Field Description
HTTPS is
enabled/disabled
State of the HTTPS server:
• Enabled
• Disabled
HTTPS is set to use port TCP port number on which the switch listens for HTTPS connections.
Last 10 connections
List of the last 10 devices to establish connections to the switch’s
HTTPS server.
IP Address
IP address of the device that established the connection.
Note: If a browser connects to a switch from behind a proxy, then only
the proxy IP address is shown. If multiple browsers connect using the
same proxy, the proxy address appears only once in the output.
Last Connected
Time when the device established the HTTPS connection to the
switch.
Time Ago (s)
Number of seconds since the device established the HTTPS connection
to the switch.
See Also:
• clear ip telnet
• set ip https server
• set ip telnet
• set ip telnet server
• show ip telnet