Filter
Top Products
D-Link DWS-1008 CLI Manual 240
802.1X Management Commands
Use 802. IEEE X management commands to modify the default settings for IEEE 802.1X sessions on
a DWS-1008 switch. For best results, change the settings only if you are aware of a problem with the
switch’s 802.1X performance.
This chapter presents 802.1X commands alphabetically. Use the following table to locate commands in
this chapter based on their use.
Caution: 802.1X parameter settings are global for all SSIDs configured on the switch.
Wired Authentication set dot1x port-control on page 248
Port Control clear dot1x port-control on page 242
set dot1x authcontrol on page 245
Keys set dot1x key-tx on page 247
set dot1x tx-period on page 251
clear dot1x tx-period on page 245
set dot1x wep-rekey on page 252
set dot1x wep-rekey-period on page 252
Bonded Authentication clear dot1x bonded-period on page 241
set dot1x bonded-period on page 246
Reauthentication set dot1x reauth-max on page 249
clear dot1x reauth-max on page 243
set dot1x reauth-period on page 250
clear dot1x reauth-period on page 243
Retransmission set dot1x quiet-period on page 249
clear dot1x quiet-period on page 242
set dot1x timeout auth-server on page 250
clear dot1x timeout auth-server on page 244
set dot1x timeout supplicant on page 251
clear dot1x timeout supplicant on page 244