Filter
Top Products
D-Link DWS-1008 CLI Manual 114
Specifies the authentication type used to authenticate
communications with the remote SNMP engine. You can
specify one of the following:
• none—No authentication is used.
• md5—Message-digest algorithm 5 is used.
• sha—Secure Hashing Algorithm (SHA) is used.
If the authentication type is md5 or sha, you can specify a
passphrase or a hexadecimal key.
• To specify a passphrase, use the auth-pass-phrase string
option. The string can be from 8 to 32 alphanumeric
characters long, with no spaces.
• To specify a key, use the auth-key hex-string option.
Specifies the encryption type used for SNMP traffic. You can
specify one of the following:
• none—No encryption is used. This is the default.
• des—Data Encryption Standard (DES) encryption is
used.
• 3des—Triple DES encryption is used.
• aes—Advanced Encryption Standard (AES) encryption is
used.
If the encryption type is des, 3des, or aes, you can specify a
passphrase or a hexadecimal key.
• To specify a passphrase, use the encrypt-pass-phrase
string option. The string can be from 8 to 32 alphanumeric
characters long, with no spaces.
• To specify a key, use the encrypt-key hex-string option.
auth-type {none | md5 | sha}
{auth-pass-phrase string |
auth-key hex-string}
encrypt-type {none | des |
3des | aes}
{encrypt-pass-phrase string |
encrypt-key hex-string}
Defaults: No SNMPv3 users are configured by default. When you configure an SNMPv3 user,
the default access is read-only, and the default authentication and encryption types are both
none.
Access: Enabled.
Examples: The following command creates USM user snmpmgr1, associated with the local
SNMP engine ID. This user can send traps to notification receivers.
DWS-1008# set snmp usm snmpmgr1 snmp-engine-id local
success: change accepted.
The following command creates USM user securesnmpmgr1, which uses SHA authentication
and 3DES encryption with passphrases. This user can send informs to the notification receiver
that has engine ID 192.168.40.2.
DWS-1008# set snmp usm securesnmpmgr1 snmp-engine-id ip 192.168.40.2 auth-
type sha auth-pass-phrase myauthpword encrypt-type 3des encrypt-pass-phrase
mycryptpword
success: change accepted.