Filter
Top Products
D-Link DWS-1008 CLI Manual 386
set service-profile tkip-mc-time
Changes the length of time that AP radios use countermeasures if two message integrity code
(MIC) failures occur within 60 seconds. When countermeasures are in effect, DWL-8220APs
dissociate all TKIP and WPA WEP clients and refuse all association and reassociation requests
until the countermeasures end.
Syntax: set service-profile name tkip-mc-time wait-time
name
wait-time
Defaults: The default countermeasures wait time is 60,000 ms (60 seconds).
Access: Enabled.
Usage: Countermeasures apply only to TKIP and WEP clients. This includes WPA WEP clients
and non-WPA WEP clients. CCMP clients are not affected.
The TKIP cipher suite must be enabled. The WPA IE also must be enabled.
Examples: The following command changes the countermeasures wait time for service profile
sp3 to 30,000 ms (30 seconds):
DWS-1008# set service-profile sp3 tkip-mc-time 30000
success: change accepted.
See Also:
• set service-profile cipher-tkip
• set service-profile wpa-ie
• show service-profile
Service profile name.
Number of milliseconds (ms) countermeasures remain in effect. You can specify
from 0 to 60,000.
set service-profile transmit-rates
Changes the data rates supported by DWL-8220APs for a service-profile’s SSID.
Syntax: set service-profile name transmit-rates {11a | 11b | 11g} mandatory rate-list
[disabled rate-list] [beacon-rate rate] [multicast-rate {rate | auto}]