Filter
Top Products
D-Link DWS-1008 CLI Manual 363
name
none
session
Defaults: The default CAC mode is none.
Access: Enabled.
Examples: The following command enables session-based CAC on service profile sp1:
DWS-1008# set service-profile sp1 cac-mode session
success: change accepted.
See Also:
• set service-profile cac-session
• show service-profile
Service profile name.
CAC is not used.
CAC is based on the number of active sessions.
set service-profile cac-session
Specifies the maximum number of active sessions a radio can have when session-based CAC is
enabled. When an DWL-8220AP has reached the maximum allowed number of active sessions,
the radio refuses connections from additional clients.
Syntax: set service-profile name cac-session max-sessions
name
max-sessions
Defaults: The default number of sessions allowed is 14.
Access: Enabled.
Usage: This command applies only when the CAC mode is session. If the CAC mode is none,
you can still change the maximum number of sessions, but the setting does not take effect until
you change the CAC mode to session. To change the CAC mode, use the set service-profile
cac-mode command.
Service profile name.
Maximum number of active sessions allowed on the radio.