Filter
Top Products
D-Link DWS-1008 CLI Manual 302
set boot partition
Specifies the boot partition in which to look for the system image file following the next system
reset, software reload, or power cycle.
Syntax: set boot partition {boot0 | boot1}
boot0 Boot partition 0.
boot1 Boot partition 1.
Defaults: By default, a switch uses the same boot partition for the next software reload that was
used to boot the currently running image.
Access: Enabled.
Usage: To determine the boot partition that was used to load the currently running software
image, use the dir command.
Examples: The following command sets the boot partition for the next software reload to partition 1:
DWS-1008# set boot partition boot1
success: Boot partition set to boot1.
show boot
Displays the system image and configuration filenames used after the last reboot and configured
for use after the next reboot.
Syntax: show boot
Defaults: None.
Access: Enabled.
Examples: The following command shows the boot information for a switch:
DWS-1008# show boot
Configured boot version: 4.1.0.65
Configured boot image: boot1:mx040100.020
Configured boot configuration: file:configuration
Backup boot configuration: file:backup.cfg
Booted version: 4.1.0.65
Booted image: boot1:mx040100.020
Booted configuration: file:configuration
Product model: switch