Filter
Top Products
D-Link DWS-1008 CLI Manual 351
Syntax: set radio-profile name rfid-mode {enable | disable}
name
enable
disable
Defaults: The default is disable.
Access: Enabled.
Examples: The following command enables radios managed by radio profile rp1 to act as asset
location receivers:
DWS-1008# set radio-profile rfid-mode enable
success: change accepted.
See Also:
• set radio-profile mode
• show radio-profile
Radio profile name.
Enables radios to function as asset location receivers.
Disables radios from functioning as asset location receivers.
set radio-profile rts-threshold
Changes the RTS threshold for the AP radios in a radio profile. The RTS threshold specifies the
maximum length a frame can be before the radio uses the RTS/CTS method to send the frame.
The RTS/CTS method clears the air of other traffic to avoid corruption of the frame due to a
collision with another frame.
Syntax: set radio-profile name rts-threshold threshold
name
threshold
Defaults: The default RTS threshold is 2346 bytes.
Access: Enabled.
Usage: You must disable all radios that are using a radio profile before you can change parameters
in the profile. Use the set radio-profile mode command.
Radio profile name.
Maximum frame length, in bytes. You can enter a value from 256 through 3000.