Filter
Top Products
D-Link DWS-1008 CLI Manual 125
Specification of the DNS domain name, DNS servers, and default router are optional. If you omit
one or more of these options, the MSS DHCP server uses oath values configured elsewhere on
the switch:
• DNS domain name—If this option is not set with the set interface dhcp-server
command’s dns-domain option, the MSS DHCP server uses the value set by the set
ip dns domain command.
• DNS servers—If these options are not set with the set interface dhcp-server
command’s primary-dns and secondary-dns options, the MSS DHCP server uses
the values set by the set ip dns server command.
• Default router—If this option is not set with the set interface dhcp-server command’s
default-router option, the MSS DHCP server can use the value set by the set ip route
command. A default route configured by set ip route can be used if the route is in the
DHCP client’s subnet. Otherwise, the MSS DHCP server does not specify a router
address.
Examples: The following command enables the DHCP server on VLAN red-vlan to serve
addresses from the 192.168.1.5 to 192.168.1.25 range:
DWS-1008# set interface red-vlan ip dhcp-server enable start 192.168.1.5 stop
192.168.1.25
success: change accepted.
See Also:
• set ip dns domain
• set ip dns server
• show dhcp-server
set interface status
Administratively disables or reenables an IP interface.
Syntax: set interface vlan-id status {up | down}
vlan-id VLAN name or number.
up Enables the interface.
down Disables the interface.
Defaults: IP interfaces are enabled by default.
Access: Enabled.
Examples: The following command disables the IP interface on VLAN mauve:
DWS-1008# set interface mauve status down
success: set interface mauve to down