Filter
Top Products
D-Link DWS-1008 CLI Manual 341
Defaults: The default interval is 60 seconds.
Access: Enabled.
Examples: The following command changes the power ramp interval for radios in radio profile
rp2 to 120 seconds:
DWS-1008# set radio-profile rp2 auto-tune power-ramp-interval 120
success: change accepted.
See Also:
• set {ap | dap} radio auto-tune max-power
• set radio-profile auto-tune power-config
• set radio-profile auto-tune power-interval
• set radio-profile auto-tune power-lockdown
• show radio-profile
set radio-profile beacon-interval
Changes the rate at which each DWL-8220AP radio in a radio profile advertises its service set
identifier (SSID).
Syntax: set radio-profile name beacon-interval interval
name
interval
Defaults: The beacon interval for DWL-8220AP radios is 100 ms by default.
Access: Enabled.
Usage: You must disable all radios that are using a radio profile before you can change parameters
in the profile. Use the set radio-profile mode command.
Examples: The following command changes the beacon interval for radio profile rp1 to 200 ms:
DWS-1008# set radio-profile rp1 beacon-interval 200
success: change accepted.
See Also:
• set radio-profile mode
• show radio-profile
Radio profile name.
Number of milliseconds (ms) between beacons. You can specify from 25 ms to
8191 ms.