Filter
Top Products
D-Link DWS-1008 CLI Manual 68
show fdb
Displays entries in the forwarding database.
Syntax: show fdb [mac-addr-glob [vlan vlan-id]]
show fdb {perm | static | dynamic | system | all} [port port-list |
vlan vlan-id]
mac-addr-glob A single MAC address or set of MAC addresses. Specify a MAC address,
or use the wildcard character (*) to specify a set of MAC addresses.
vlan vlan-id Name or number of a VLAN for which to display entries.
perm Displays permanent entries. A permanent entry does not age out and
remains in the database even after a reboot, reset, or power cycle.
static Displays static entries. A static entry does not age out, but is removed
from the database after a reboot, reset, or power cycle.
dynamic Displays dynamic entries. A dynamic entry is automatically removed
through aging or after a reboot, reset, or power cycle.
system Displays system entries. A system entry is added by MSS. For example,
the authentication protocols can add entries for wired and wireless
authentication users.
all Displays all entries in the database, or all the entries that match a
particular port or ports or a particular VLAN.
port port-list Destination port(s) for which to display entries.
Defaults: None.
Access: All.
Usage: To display the entire forwarding database, enter the show fdb command without options.
To display only a portion of the database, use optional parameters to specify the types of entries
you want to display.
Examples: The following command displays all entries in the forwarding database:
DWS-1008# show fdb all
* = Static Entry. + = Permanent Entry. # = System Entry.
VLAN TAG Dest MAC/Route Des [CoS] Destination Ports [Protocol Type]
-------------------------------------------------------------------------------------------------------------------------
1 00:01:97:13:0b:1f 1 [ALL]
1 aa:bb:cc:dd:ee:ff * 3 [ALL]
1 00:0b:0e:02:76:f5 1 [ALL]
Total Matching FDB Entries Displayed = 3