Filter
Top Products
D-Link DWS-1008 CLI Manual 385
set service-profile static-cos
Enables or disables static CoS on a service profile. Static CoS assigns the same CoS level to
all traffic on the service profile’s SSID, regardless of 802.1p or DSCP markings in the packets
themselves, and regardless of any ACLs that mark CoS. This option provides a simple way to
configure an SSID for priority traffic such as VoIP traffic.
When static CoS is enabled, the standard MSS prioritization mechanism is not used. Instead, the
AP sets CoS as follows:
Syntax: set service-profile name static-cos {enable | disable}
name
enable
disable
Defaults: Static CoS is disabled by default.
Access: Enabled.
Usage: The CoS level is specified by the set service-profile cos command.
Examples: The following command enables static CoS on service profile sp1:
DWS-1008# set service-profile sp1 static-cos enable
success: change accepted.
See Also:
• set service-profile cos
• show service-profile
Service profile name.
Enables static CoS on the service profile.
Disables static CoS on the service profile.
• For traffic from the AP to clients, the AP places the traffic into the forwarding queue
that corresponds to the CoS level configured on the service profile. For example, if
the static CoS level is set to 7, the AP radio places client traffic in its Voice queue.
• For traffic from clients to the network, the AP marks the DSCP value in the IP headers
of the tunnel packets used to carry the user data from the AP to the DWS-1008.