Filter
Top Products
D-Link DWS-1008 CLI Manual 508
set log mark
Configures MSS to generate mark messages at regular intervals. The mark messages indicate the
current system time and date. D-Link can use the mark messages to determine the approximate
time when a system restart or other event causing a system outage occurred.
Syntax: set log mark [enable | disable] [severity level] [interval interval]
enable Enables the mark messages.
disable Disables the mark messages.
severity level Log severity at which the messages are logged:
• emergency
• alert
• critical
• error
• warning
• notice
• info
• debug
interval interval Interval at which MSS generates the mark messages. You can specify from
1 to 2147483647 seconds.
Defaults: Mark messages are disabled by default. When they are enabled, MSS generates a
message at the notice level once every 300 seconds by default.
Access: Enabled.
Examples: The following command enables mark messages:
DWS-1008# set log mark enable
success: change accepted.
See Also:
• show log config