Filter
Top Products
D-Link DWS-1008 CLI Manual 315
Defaults: The default radio type for the DWL-8220AP is 802.11g.
Access: Enabled
Examples: The following command sets the radio type to 802.11b:
DWS-1008# set dap auto radiotype 11b
success: change accepted.
See Also:
• set dap auto
• set dap auto mode
• set dap auto persistent
set {ap | dap} bias
Changes the bias for an AP. Bias is the priority of one DWS-1008 switch over other DWS-1008
switches for booting and configuring the AP.
Syntax: set {ap port-list | dap {dap-num | auto}} bias {high | low}
ap port-list
dap dap-num
dap auto
high
low
Defaults: The default bias is high.
Access: Enabled
Usage: High bias is preferred over low bias. Bias applies only to DWS-1008 switches that are
indirectly attached to the AP through an intermediate Layer 2 or Layer 3 network. An AP always
attempts to boot on AP port 1 first, and if a DWS-1008 is directly attached on AP port 1, the AP
always boots from it.
List of ports on which to change the bias for directly connected APs.
Number of a Distributed AP for which to change the bias.
Configures bias for the AP configuration profile.
High bias.
Low bias.