Filter
Top Products
D-Link DWS-1008 CLI Manual 142
SNMPv2c with Informs
To configure a notification target for informs from SNMPv2c, use the following command:
Syntax: set snmp notify target target-num ip-addr [:udp-port-number]
v2c community-string inform [profile profile-name] [retries num] [timeout num]
target-num ID for the target. This ID is local to the switch and does not
need to correspond to a value on the target itself. You
can specify a number from 1 to 10.
ip-addr [:udp-port-number] IP address of the server. You also can specify the UDP port
number to send notifications to.
community-string Community string.
profile profile-name Notification profile this SNMP user will use to specify the
notification types to send or drop.
retries num Specifies the number of times the MSS SNMP engine will
resend a notification that has not been acknowledged
by the target. You can specify from 0 to 3 retries.
timeout num Specifies the number of seconds MSS waits for
acknowledgement of a notification. You can specify from 1 to
5 seconds.
SNMPv2c with Traps
To configure a notification target for traps from SNMPv2c, use the following command:
Syntax: set snmp notify target target-num ip-addr [:udp-port-number]
v2c community-string trap [profile profile-name]
target-num ID for the target. This ID is local to the switch and does not
need to correspond to a value on the target itself. You
can specify a number from 1 to 10.
ip-addr [:udp-port-number] IP address of the server. You also can specify the UDP port
number to send notifications to.
community-string Community string.
profile profile-name Notification profile this SNMP user will use to specify the
notification types to send or drop.