Filter
Top Products
D-Link DWS-1008 CLI Manual 140
set snmp notify target
Configures a notification target for notifications from SNMP.
A notification target is a remote device to which MSS sends SNMP notifications. You can configure
the MSS SNMP engine to send confirmed notifications (informs) or unconfirmed notifications
(traps). Some of the command options differ depending on the SNMP version and the type of
notification you specify.
You can configure up to 10 notification targets.
SNMPv3 with Informs
To configure a notification target for informs from SNMPv3, use the following command:
Syntax: set snmp notify target target-num ip-addr [:udp-port-number]
usm inform user username snmp-engine-id {ip | hex hex-string}
[profile profile-name] [security {unsecured | authenticated | encrypted}]
[retries num] [timeout num]
target-num ID for the target. This ID is local to the switch and does not need to
correspond to a value on the target itself. You can specify a number
from 1 to 10.
ip-addr[:udp-port-number] IP address of the server. You also can specify the UDP port number
to send notifications to.
username USM username. This option is applicable only when the SNMP
version is usm. If the user will send informs rather than traps,
you also must specify the snmp-engine-id of the target.
snmp-engine-id SNMP engine ID of the target. Specify ip if SNMP engine ID
{ip | hex hex-string} the target’s SNMP engine ID is based on its IP address. If the
target’s SNMP engine ID is a hexadecimal value, use hex hex-string
to specify the value.
profile profile-name Notification profile this SNMP user will use to specify the notification
types to send or drop.
security {unsecured | Specifies the security level, and is applicable only when the
authenticated | encrypted} SNMP version is usm:
• unsecured—Message exchanges are not authenticated,
nor are they encrypted. This is the default.
• authenticated—Message exchanges are authenticated,
but are not encrypted.
• encrypted—Message exchanges are authenticated and
encrypted.