Filter
Top Products
D-Link DWS-1008 CLI Manual 39
Usage: Each type of statistic is displayed separately. Press the Spacebar to cycle through the
displays for each type.
If you use an option to specify a statistic type, the display begins with that statistic type. You can
use one statistic option with the command.
Use the keys listed the following table to control the monitor display
Key Effect on monitor display
Spacebar Advances to the next statistic type.
Esc Exits the monitor. MSS stops displaying the statistics and displays a new command
prompt.
c Clears the statistics counters for the currently displayed statistics type. The counters
begin incrementing again.
For error reporting, the cyclic redundancy check (CRC) errors include misalignment errors.
Jumbo packets with valid CRCs are not counted. A short packet can be reported as a short
packet, a CRC error, or an overrun. In some circumstances, the transmitted octets counter
might increment a small amount for a port with nothing attached.
Examples: The following command starts the port statistics monitor beginning with octet
statistics (the default):
Syntax: monitor port counters
As soon as you press Enter, MSS clears the window and displays statistics at the top of the
window.
Port Status Rx Octets Tx Octets
=========================================
1 Up 27965420 34886544
...
To cycle the display to the next set of statistics, press the Spacebar. In this example, packet
statistics are displayed next:
Port Status Rx Unicast Rx NonUnicast Tx Unicast Tx NonUnicast
===========================================================
1 Up 54620 62144 58318 62556
...
The following table describes the port statistics displayed by each statistics option. The Port and
Status fields are displayed for each option.