Filter
Top Products
D-Link DWS-1008 CLI Manual 353
Parameter Default Value Radio Behavior When Parameter Set to Default Value
cac-mode none
Does not limit the number of active user sessions based on Call
Admission Control.
cac-session 14
If session-based CAC is enabled (cac-mode is set to session),
limits the number of active user sessions on a radio to 14.
cipher-ccmp disable
Does not use Counter with Cipher Block Chaining Message
Authentication Code Protocol (CCMP) to encrypt traffic sent to
WPA clients.
cipher-tkip enable
When WPA IE is enabled, uses Temporal Key Integrity Protocol
(TKIP) to encryp traffic sent to WPA clients.
cipher-wep104 disable
Does not use Wired Equivalent Privacy with
104-bit keys to encrypt traffic sent to WPA clients.
cipher-wep40 disable
Does not user WEP with 40-bit keys to encrypt traffic sent to WPA
clents.
cos 0
If static CoS is enabled (static-cos is set to enable) assigns CoS
to all data traffic to or from clients.
dhcp-restrict disable
Does not restrict a client’s traffic to only DHCP traffic while the
client is being authenticated and authorized.
idle-client-probing enable
Sends a keepalive packet (a null-data frame) to each client every
10 seconds.
keep-initial-vlan disable
Reassigns the user to a VLAN after roaming, instead of leaving
the roamed user on the VLAN assigned by the switch where the
user is logged on.
Note: Enabling the option does not retain the user’s initial VLAN
assignment in all cases.
long-retry-count 5
Sends a long unicast frame up to five times without
acknowledgement.
no-broadcast disable
Does not reduce wireless broadcast traffic by sending unicasts to
clients for ARP requests and DHCP Offers and Acks instead of
forwarding them as multicasts.
proxy-arp disable
Does not reply on behalf of wireless clients to ARP requests for
client IP addresses. Instead, the radio forwards the ARP Requests
as wireless broadcasts.
Table: Defaults for Radio Profile Parameters (continued)