Filter
Top Products
D-Link DWS-1008 CLI Manual 339
set radio-profile auto-tune power-interval
Sets the interval at which RF Auto-Tuning decides whether to change the power level on radios in
a radio profile. At the end of each interval, MSS processes the results of the RF scans performed
during the previous interval, and changes radio power levels if needed.
Syntax: set radio-profile name auto-tune power-interval seconds
name
seconds
Defaults: The default power tuning interval is 300 seconds.
Access: Enabled.
Usage: RF Auto-Tuning also can temporarily increase a radio’s power level to preserve the
minimum data rate for an associated client. In this case, the radio reduces its power in 1 dBm
increments until the power returns to the expected level.
Examples: The following command sets the power interval for radios in radio profile rp2 to 240
seconds:
DWS-1008# set radio-profile rp2 auto-tune power-interval 240
success: change accepted.
See Also:
• set {ap | dap} radio auto-tune max-power
• set radio-profile auto-tune channel-config
• set radio-profile auto-tune power-lockdown
• set radio-profile auto-tune power-ramp-interval
• show service profile
Radio profile name.
Number of seconds MSS waits before changing radio power levels to adjust to
RF changes, if needed. You can specify from 1 to 65535 seconds.