Filter
Top Products
D-Link DWS-1008 CLI Manual 321
set dap fingerprint
Verifies an AP’s fingerprint on an DWS-1008. If AP-DWS security is required by an DWS-1008,
an AP can establish a management session with the switch only if you have verified the AP’s
identity by verifying its fingerprint on the switch.
Syntax: set dap dap-num fingerprint hex
dap dap-num
hex
Defaults: None.
Access: Enabled
Usage: APs are configured with an encryption key pair at the factory. The fingerprint for the
public key is displayed on a label on the back of the AP, in the following format:
RSA
aaaa:aaaa:aaaa:aaaa:aaaa:aaaa:aaaa:aaaa
If an AP is already installed and operating, you can use the show dap status command to display
the fingerprint. The show dap config command lists an AP’s fingerprint only if the fingerprint has
been verified in MSS. If the fingerprint has not been verified, the fingerprint information in the
command output is blank.
Examples: The following example verifies the fingerprint for Distributed AP 8:
DWS-1008# set dap 8 fingerprint b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
success: change accepted.
See Also:
• set dap security
• show {ap | dap} config
• show {ap | dap} status
Number of the Distributed AP whose fingerprint you are verifying.
The 16-digit hexadecimal number of the fingerprint. Use a colon
between each digit. Make sure the fingerprint you enter matches the
fingerprint used by the AP.