Filter
Top Products
D-Link DWS-1008 CLI Manual 343
The following command causes radios managed by radio profile radprof3 to issue countermeasures
against devices in the DWS-1008’s attack list:
DWS-1008# radio-profile radprof3 countermeasures configured
success: change accepted.
Note that when you issue this command, countermeasures are then issued only against devices
in the DWS-1008’s attack list, not against other devices that were classified as rogues by other
means.
See Also:
• show radio-profile
set radio-profile dtim-interval
Changes the number of times after every beacon that each DWL-8220AP radio in a radio profile
sends a delivery traffic indication map (DTIM). An DWL-8220AP access point sends the multicast
and broadcast frames stored in its buffers to clients who request them in response to the DTIM.
Note: The DTIM interval applies to both the beaconed SSID and the nonbeaconed SSID.
Syntax: set radio-profile name beacon-interval interval
name
interval
Defaults: By default, DWL-8220AP access points send the DTIM once after each beacon.
Access: Enabled.
Usage: You must disable all radios that are using a radio profile before you can change parameters
in the profile. Use the set radio-profile mode command.
The DTIM interval does not apply to unicast frames.
Examples: The following command changes the DTIM interval for radio profile rp1 to 2:
DWS-1008# set radio-profile rp1 dtim-interval 2
success: change accepted.
See Also:
• set radio-profile mode
• show radio-profile
Radio profile name.
Number of times the DTIM is transmitted after every beacon. You can enter a
value from 1 through 31.