Filter
Top Products
D-Link DWS-1008 CLI Manual 500
set snoop map
Maps a snoop filter to a radio on a Distributed AP. A snoop filter does take effect until you map it
to a radio and enable the filter.
Examples: set snoop map filter-name dap dap-num radio {1 | 2}
filter-name Name of the snoop filter.
dap dap-num Number of a Distributed AP to which to map the snoop filter.
radio 1 Radio 1 of the AP.
radio 2 Radio 2 of the AP. (This option does not apply to single-radio models.)
Defaults: Snoop filters are unmapped by default.
Access: Enabled.
Usage: You can map the same filter to more than one radio. You can map up to eight filters to
the same radio. If more than one filter has the same observer, the AP sends only one copy of a
packet that matches a filter to the observer. After the first match, the AP sends the packet and
stops comparing the packet against other filters for the same observer.
If the filter does not have an observer, the AP still maintains a counter of the number of packets
that match the filter.
Examples: The following command maps snoop filter snoop1 to radio 2 on Distributed AP 3:
DWS-1008# set snoop map snoop1 dap 3 radio 2
success: change accepted.
See Also:
• clear snoop map
• set snoop
• set snoop mode
• show snoop map
• show snoop stats