Filter
Top Products
D-Link DWS-1008 CLI Manual 237
Defaults: Default values are listed below:
• auth-port—UDP port1812
• acct-port—UDP port1813
• timeout—5 seconds
• retransmit—3 (the total number of attempts, including the first attempt)
• deadtime—0 (zero) minutes (The switch does not designate unresponsive RADIUS
servers as unavailable.)
• key—No key
• encrypted-key—No key
• author-password—trapeze
Access: Enabled.
Usage: or a given RADIUS server, the first instance of this command must set both the server
name and the IP address and can include any or all of the other optional parameters. Subsequent
instances of this command can be used to set optional parameters for a given RADIUS server.
To configure the server as a remote authenticator for the switch, you must add it to a server group
with the set server group command.
Do not use the same name for a RADIUS server and a RADIUS server group.
Examples: To set a RADIUS server named RS42 with IP address 198.162.1.1 to use the default
accounting and authorization ports with a timeout interval of 30 seconds, two transmit attempts,
5 minutes of dead time, a key string of keys4u, and the default authorization password of dlink,
type the following command:
DWS-1008# set radius server RS42 address 198.162.1.1 timeout 30 retransmit 2
deadtime 5 key keys4U
See Also:
• set authentication admin
• set authentication console
• set authentication dot1x
• set authentication mac
• set authentication web
• set radius
• set server group
• show aaa