Filter
Top Products
D-Link DWS-1008 CLI Manual 313
Examples: The following command creates a profile for automatic Distributed AP
configuration:
DWS-1008# set dap auto
success: change accepted.
See Also:
• set dap auto mode
• set dap auto persistent
• set dap auto radiotype
• set {ap | dap} bias
• set {ap | dap} blink
• set {ap | dap} group
• set {ap | dap} radio auto-tune max-power
• set {ap | dap} radio mode
• set {ap | dap} radio radio-profile
• set {ap | dap} upgrade-firmware
set dap auto mode
Enables an DWS-1008’s profile for automatic Distributed AP configuration.
Syntax: set dap auto mode {enable | disable}
enable
disable
Defaults: The AP configuration profile is disabled by default.
Access: Enabled
Usage: You must use the set dap auto command to create the profile before you can enable it.
Examples: The following command enables the profile for automatic Distributed AP
configuration:
DWS-1008# set dap auto mode enable
success: change accepted.
Enables the AP configuration profile.
Disables the AP configuration profile.