Filter
Top Products
D-Link DWS-1008 CLI Manual 271
MSS can place a client in the black list due to an association, reassociation or disassociation
flood from the client.
The client black list applies only to the switch on which the list is configured. Switches do not
share client black lists.
Examples: The following command adds client MAC address 11:22:33:44:55:66 to the black
list:
DWS-1008# set rfdetect black-list 11:22:33:44:55:66
success: MAC 11:22:33:44:55:66 is now blacklisted.
See Also:
• set rfdetect black-list
• show rfdetect black-list
set rfdetect ignore
Configures a list of known devices to ignore during an RF scan. MSS does not generate log
messages or traps for the devices in the ignore list.
Syntax: set rfdetect ignore mac-addr
mac-addr BSSID (MAC address) of the device to ignore.
Defaults: MSS reports all non-D-Link BSSIDs detected during an RF scan.
Access: Enabled.
Usage: Use this command to identify third-party APs and other devices you are already aware of
and do not want MSS to report following RF scans.
If you try to initiate countermeasures against a device on the ignore list, the ignore list takes
precedence and MSS does not issue the countermeasures. Countermeasures apply only to
rogue devices.
If you add a device that MSS has classified as a rogue to the permitted vendor list or permitted
SSID list, but not to the ignore list, MSS can still classify the device as a rogue. Adding an entry to
the permitted vendor list or permitted SSID list merely indicates that the device is from an allowed
manufacturer or is using an allowed SSID. However, to cause MSS to stop classifying the device
as a rogue, you must add the device’s MAC address to the ignore list.
Examples: The following command configures MSS to ignore BSSID aa:bb:cc:11:22:33 during
RF scans:
DWS-1008# set rfdetect ignore aa:bb:cc:11:22:33
success: MAC aa:bb:cc:11:22:33 is now ignored.