Filter
Top Products
D-Link DWS-1008 CLI Manual 58
show port status
Displays configuration and status information for ports.
Syntax: show port status [port-list]
port-list List of physical ports. If you do not specify a port list, information is displayed for
all ports.
Defaults: None.
Access: All.
Examples: The following command displays information for all ports on a DWS-1008:
DWS-1008# show port status
Port Name Admin Oper Config Actual Type Media
===============================================================
1 1 up up auto 100/full network 10/100BaseTx
2 2 up down auto network 10/100BaseTx
3 3 up down auto network 10/100BaseTx
4 4 up down auto network 10/100BaseTx
5 5 up down auto network 10/100BaseTx
6 6 up down auto network 10/100BaseTx
7 7 up down auto network no connector
8 8 up down auto network no connector
The table below describes the fields in this display.
Field Description
Port
Port number.
Name Port name. If the port does not have a name, the port number is listed.
Admin
Administrative status of the port:
• up—The port is enabled.
• down—The port is disabled.
Oper
Operational status of the port:
• up—The port is operational.
• down—The port is not operational.
Config
Port speed configured on the port:
• 10—10 Mbps.
• 100—100 Mbps.
• auto—The port sets its own speed.
Actual Speed and operating mode in effect on the port.
Type
Port type:
• ap—AP access point port
• network—Network port
• wa—Wired authentication port
Media
Link type:
• 10/100BaseTX—10/100BASE-T.