Filter
Top Products
D-Link DWS-1008 CLI Manual 161
Field Description
Gateway
Next-hop router for reaching the route destination.
Note: This field applies only to static routes.
VLAN:Interface
Destination VLAN, protocol type, and IP address of the route. Because direct routes are for
local interfaces, a destination IP address is not listed. The destination for the IP multicast
route is MULTICAST.
For static routes, the value Down means the switch does not have an interface to the
destination’s next-hop router. To provide an interface, configure an IP interface that is in the
same IP subnet as the next-hop router. The IP interface must be on a VLAN containing the
port that is attached to the default router.
show ip telnet
Displays information about the Telnet management port.
Syntax: show ip telnet
Defaults: None.
Access: All.
Examples: The following command shows the status and port number for the Telnet management
interface to the switch:
DWS-1008> show ip telnet
Server Status Port
----------------------------------
Enabled 23
The table below describes the fields in this display.
Field Description
Server Status State of the HTTPS server:
• Enabled
• Disabled
Port TCP port number on which the switch listens for
Telnet management traffic.
See Also:
• clear ip telnet
• set ip https server
• set ip telnet
• set ip telnet server
• show ip https