Filter
Top Products
D-Link DWS-1008 CLI Manual 307
Access Point Commands
Use DWL-8220AP access point commands to configure and manage DWL-8220AP access points. Be
sure to do the following before using the commands:
• Define the country-specific IEEE 802.11 regulations on the DWS-1008 switch.
• Install the DWL-8220AP access point and connect it to a port on the switch.
• Configure an DWL-8220AP access port (for a directly connected AP) or a Distributed AP).
Caution:
Changing the system country code after DWL-8220AP configuration disables
DWL-8220AP access points and deletes their configuration. If you change the country
code on a switch, you must reconfigure all DWL-8220AP access points.
clear {ap | dap} radio
Disables an DWL-8220AP radio and resets it to its factory default settings.
Syntax: clear {ap port-list | dap dap-num} radio {1 | 2 | all}
ap port-list
dap dap-num
radio 1
radio 2
radio all
Defaults: The clear ap radio command resets the radio to the default settings.
Usage: When you clear a radio, MSS performs the following actions:
• Clears the transmit power, channel, and external antenna setting from the radio.
• Removes the radio from its radio profile and places the radio in the default radio profile.
This command does not affect the PoE (Power over Ethernet) setting.
List of ports connected to the DWL-8220AP access point(s) on which to
reset a radio.
Number of a Distributed AP on which to reset a radio.
Radio 1 of the DWL-8220AP.
Radio 2 of the DWL-8220AP.
All radios on the DWL-8220AP.