Filter
Top Products
D-Link DWS-1008 CLI Manual 134
set ntp server
Configures a DWS-1008 switch to use an NTP server.
Syntax: set ntp server ip-addr
ip-addr IP address of the NTP server, in dotted decimal notation.
Defaults: None.
Access: Enabled.
Usage: You can configure up to three NTP servers. MSS queries all the servers and selects the
best response based on the method described in RFC 1305, Network Time Protocol (Version 3)
Specification, Implementation and Analysis.
To use NTP, you also must enable the NTP client with the set ntp command.
Examples: The following command configures a switch to use NTP server 192.168.1.5:
DWS-1008# set ntp server 192.168.1.5
See Also:
• clear ntp server
• clear ntp update-interval
• set ntp
• set ntp update-interval
• show ntp
set ntp update-interval
Changes how often MSS sends queries to the NTP servers for updates.
Syntax: set ntp update-interval seconds
seconds Number of seconds between queries. You can specify from 16 through 1024
seconds.
Defaults: The default NTP update interval is 64 seconds.
Access: Enabled.
Examples: The following command changes the NTP update interval to 128 seconds:
DWS-1008# set ntp update-interval 128
success: change accepted.