Filter
Top Products
D-Link DWS-1008 CLI Manual 420
show dap unconfigured
Displays Distributed APs that are physically connected to the network but that are not configured
on any DWS-1008s.
Syntax: show dap unconfigured
Defaults: None.
Access: Enabled.
Usage: This command also displays an AP that is directly connected to an DWS-1008, if the
switch port to which the AP is connected is configured as a network port instead of an AP access
port, and if the network port is a member of a VLAN.
Entries in the command output’s table age out after two minutes.
Examples: The following command displays information for two Distributed APs that are not
configured:
DWS-1008# show dap unconfigured
Total number of entries: 2
Field Description
Serial Id
Serial ID of the Distributed AP.
Model
AP model number.
IP Address
IP address of the AP. This is the address that the AP receives from a DHCP
server. The AP uses this address to send a Find DWS message to request
configuration information from DWL-1008.
However, the AP cannot use the address to establish a connection unless the
AP first receives a configuration from an DWS-1008.
Port
Port number on which this DWS-1008 received the AP’s Find DWS message.
VLAN
VLAN on which this DWS-1008 received the AP’s Find DWS message.
The following table describes the fields in the display:
Serial Id Model IP Address Port Vlan
0333001287 DWL-8220AP 10.3.8.54 5 default
0333001285 DWL-8220AP 10.3.8.57 7 vlan-eng