Filter
Top Products
D-Link DWS-1008 CLI Manual 327
Defaults: All radios use the internal antenna by default.
Access: Enabled
Examples: The following command configures the 802.11b/g radio on Distributed AP 1 to use
antenna model ANT1060:
DWS-1008# set dap 1 radio 1 antennatype ANT1060
success: change accepted.
See Also:
• show {ap | dap} config
set {ap | dap} radio auto-tune max-power
Sets the maximum power that RF Auto-Tuning can set on a radio.
Syntax: set {ap port-list | dap {dap-num | auto}} radio {1 | 2} auto-tune max-power
power-level
ap port-list
dap dap-num
dap auto
radio 1
radio 2
power-level
Defaults: The default maximum power setting that RF Auto-Tuning can set on a radio is the
highest setting allowed for the country of operation or highest setting supported on the hardware,
whichever is lower.
Access: Enabled.
List of ports connected to the DWL-8220AP access points on which to
set the maximum power.
Number of a Distributed AP on which to set the maximum power.
Sets the maximum power for radios configured by the DWL-8220AP
configuration template.
Radio 1 of the DWL-8220AP.
Radio 2 of the DWL-8220AP.
Maximum power setting RF Auto-Tuning can assign to the radio,
expressed as the number of decibels in relation to 1 milliwatt (dBm). You
can specify a value from 1 up to the maximum value allowed for the
country of operation. The power-level can be a value from 1 to 20.