Filter
Top Products
D-Link DWS-1008 CLI Manual 417
show dap connection
Displays the system IP address of the DWS-1008 that booted a Distributed AP.
Syntax: show dap connection [dap-num | serial-id serial-ID]
dap-num
serial-id
Defaults: None.
Access: Enabled.
Usage: The serial-id parameter displays the active connection for the specified Distributed AP
even if that AP is not configured on this DWS-1008. If you instead use the command with the
dap-num parameter or without a parameter, connection information is displayed only for Distributed
APs that are configured on this DWS-1008.
This command provides information only if the Distributed AP is configured on the switch where
you use the command. The switch does not need to be the one that booted the AP, but it must
have the AP in its configuration.
If a Distributed AP is configured on this DWS-1008 but does not have an active connection,
the command does not display information for the AP. To show connection information for
Distributed APs, use the show dap global command on one of the switches where the APs are
configured.
Examples: The following command displays information for all Distributed APs configured on
this DWS-1008 that have active connections:
DWS-1008# show dap connection
Total number of entries: 2
Number of a Distributed AP for which to display information about its active
connection.
DWL-8220AP access point serial ID.
DAP Serial Id DAP IP Address DWS-1008 IP Address
2 112233 10.10.2.27 10.3.8.111
4 0333000298 10.10.3.34 10.3.8.111