Filter
Top Products
D-Link DWS-1008 CLI Manual 71
Examples: The following command shows Layer 2 forwarding restriction information for all
VLANs:
DWS-1008# show security l2-restrict
VLAN Name En Drops Permit MAC Hits
-------------------------------------------------------------------------------------------------
1 default Y 0 00:0b:0e:02:53:3e 5947
00:30:b6:3e:5c:a8 9
2 vlan-2 Y 0 04:04:04:04:04:04 0
The table describes the fields in the display.
Field Discription
VLAN VLAN number.
Name VLAN name.
En
Enabled state of the feature for the VLAN:
• Y—Enabled. Forwarding of Layer 2 traffic from clients is restricted to the MAC address(es)
listed under Permit MAC.
• N—Disabled. Layer 2 forwarding is not restricted.
Drops
Number of packets dropped because the destination MAC address was not one of the
addresses listed under Permit MAC.
Permit MAC MAC addresses to which clients in the VLAN are allowed to send traffic at Layer 2.
Hits
Number of packets whose source MAC address was a client in this VLAN, and whose
destination MAC address was one of those listed under Permit MAC.
See Also:
• clear security l2-restrict
• clear security l2-restrict counters
• set security l2-restrict
show vlan config
Displays VLAN information.
Syntax: show vlan config [vlan-id]
vlan-id VLAN name or number. If you do not specify a VLAN, information for all VLANs is
displayed.
Defaults: None.
Access: All.