Filter
Top Products
D-Link DWS-1008 CLI Manual 72
Examples: The following command displays information for VLAN burgundy:
DWS-1008# show vlan config burgundy
Admin VLAN Tunl Port
VLAN Name Status State Affin Port Tag State
-------------------------------------------------------------------------------------------------------
2 burgundy Up Up 5
2 none Up
3 none Up
4 none Up
5 none Up
6 none Up
t:10.10.40.4 none Up
The table below describes the fields in this display.
Field Description
VLAN VLAN number.
Name VLAN name.
Admin Status
Administrative status of the VLAN:
• Down—The VLAN is disabled.
• Up—The VLAN is enabled.
VLAN State
Link status of the VLAN:
• Down—The VLAN is not connected.
• Up—The VLAN is connected.
Tunl Affin Tunnel affinity value assigned to the VLAN.
Port
Member port of the VLAN. The port can be a physical port or a virtual port.
• Physical ports are 10/100 Ethernet on the switch, and are listed by port number.
• Virtual ports are tunnels to other switches in a mobility domain, and are listed as follows:
t:ip-addr, where ip-addr is the system IP address of the switch at the other end of the
tunnel.
Note: This field can include AP access ports and wired authentication ports, because MSS
dynamically adds these ports to a VLAN when handling user traffic for the VLAN.
Tag Tag value assigned to the port.
Port State
Link state of the port:
• Down—The port is not connected.
• Up—The port is connected.
See Also:
• clear vlan
• set vlan name
• set vlan port