Filter
Top Products
D-Link DWS-1008 CLI Manual 49
DWS-1008# set port poe 3,5 disable
If you are enabling power on these ports, they must be connected only to
approved PoE devices with the correct wiring. Do you wish to continue?
(y/n) [n]y
The following command enables PoE on ports 2 and 4:
DWS-1008# set port poe 2,4 enable
If you are enabling power on these ports, they must be connected only to
approved PoE devices with the correct wiring. Do you wish to continue?
(y/n) [n]y
See Also:
• set port type ap
• set port type wired-auth
set port speed
Changes the speed of a port.
Syntax: set port speed port-list {10 | 100 | auto}
port-list
Defaults: All ports are set to auto.
Access: Enabled.
Usage: D-Link recommends that you do not configure the mode of a switch port so that one
side of the link is set to autonegotiation while the other side is set to full-duplex. Although MSS
allows this configuration, it can result in slow throughput on the link. The slow throughput occurs
because the side that is configured for autonegotiation falls back to half-duplex. A stream of
large packets sent to a switch port in such a configuration can cause forwarding on the link to
stop.
List of physical ports. MSS sets the port speed on all the specified ports.
Sets the port speed of a 10/100 Ethernet port to 10 Mbps and sets the
operating mode to full-duplex.
Sets the port speed of a 10/100 Ethernet port to 100 Mbps and sets the
operating mode to full-duplex.
Enables a port to detect the speed and operating mode of the traffic on the
link and set itself accordingly.
10
100
auto