Filter
Top Products
D-Link DWS-1008 CLI Manual 229
clear radius client system-ip
Removes the switch’s system IP address from use as the permanent source address in RADIUS
client requests from the switch to its RADIUS server(s).
Syntax: clear radius client system-ip
deadtime Number of minutes to wait after declaring an unresponsive RADIUS server
unavailable before retrying the RADIUS server.
key Password (shared secret key) used to authenticate to the RADIUS server.
retransmit Number of transmission attempts made before declaring an unresponsive
RADIUS server unavailable.
timeout Number of seconds to wait for the RADIUS server to respond before
retransmitting.
Defaults: None
Access: Enabled.
Usage: The clear radius client system-ip command causes the switch to use the IP address
of the interface through which it sends a RADIUS client request as the source IP address. The
switch selects a source interface address based on information in its routing table as the source
address for RADIUS packets leaving the switch.
Examples: To clear the system IP address as the permanent source address for RADIUS client
requests, type the following command:
DWS-1008# clear radius client system-ip
success: change accepted.
See Also:
• set radius client system-ip
• show aaa