Filter
Top Products
D-Link DWS-1008 CLI Manual 77
IP Services Commands
Use IP services commands to configure and manage IP interfaces, management services, the Domain
Name Service (DNS), Network Time Protocol (NTP), and aliases, and to ping a host or trace a route.
This chapter presents IP services commands alphabetically.
clear interface
Removes an IP interface.
Syntax: clear interface vlan-id ip
vlan-id VLAN name or number.
Defaults: None.
Access: Enabled.
Usage: If the interface you want to remove is configured as the system IP address, removing the
address can interfere with system tasks that use the system IP address, including the following:
• Topology reporting for dual-homed access points
• Default source IP address used in unsolicited communications such as AAA
accounting reports and SNMP traps
Examples: The following command removes the IP interface configured on VLAN mauve:
DWS-1008# clear interface mauve ip
success: cleared ip on vlan mauve
See Also:
• set interface
• set interface status
• show interface