Filter
Top Products
D-Link DWS-1008 CLI Manual 456
set igmp qi
Changes the IGMP query interval timer on one VLAN or all VLANs on a switch.
Syntax: set igmp qi seconds [vlan vlan-id]
qi seconds Number of seconds that elapse between general queries sent by the switch
when the switch is the querier for the subnet. You can specify a value from 1
through 65,535.
vlan vlan-id VLAN name or number. If you do not specify a VLAN, the timer change applies
to all VLANs.
Defaults: The default query interval is 125 seconds.
Access: Enabled.
Usage: The query interval is applicable only when the switch is querier for the subnet. For the
switch to become the querier, the pseudo-querier feature must be enabled on the switch and the
switch must have the lowest IP address among all the devices eligible to become a querier. To
enable the pseudo-querier feature, use the set igmp querier command.
Examples: The following command changes the query interval on VLAN orange to 100
seconds:
DWS-1008# set igmp qi 100 vlan orange
success: change accepted.
See Also:
• set igmp lmqi
• set igmp oqi
• set igmp qri
• set igmp querier
• set igmp mrouter
• set igmp rv