Filter
Top Products
D-Link DWS-1008 CLI Manual 227
RADIUS and Server Groups Commands
Use RADIUS commands to set up communication between a switch and groups of up to four RADIUS
servers for remote authentication, authorization, and accounting (AAA) of administrators and network
users. This chapter presents RADIUS commands alphabetically. Use the following table to locate
commands in this chapter based on their uses.
RADIUS Client set radius client system-ip on page 234
clear radius client system-ip on page 229
RADIUS Servers set radius on page 232
set radius server on page 236
clear radius on page 228
clear radius server on page 231
Server Groups set server group on page 238
set server group load-balance on page 239
clear server group on page 231
RADIUS Proxy set radius proxy client on page 234
set radius proxy port on page 235
clear radius proxy client on page 230
clear radius proxy port on page 230
(For information about RADIUS attributes, see the RADIUS appendix in the D-Link Mobility System
Software Configuration Guide.)