Filter
Top Products
D-Link DWS-1008 CLI Manual 490
Trace Commands
Use trace commands to perform diagnostic routines. While MSS allows you to run many types of traces,
this chapter describes commands for those traces you are most likely to use. For a complete listing of
the types of traces MSS allows, type the set trace ? command.
Caution: Using the set trace command can have adverse effects on system performance. D-Link
recommends that you use the lowest levels possible for initial trace commands, and slowly increase the
levels to get the data you need.
This chapter presents trace commands alphabetically. Use the following table to locate commands in
this chapter based on their use.
Trace clear log trace on page 490
clear trace on page 491
save trace on page 492
set trace authentication on page 492
set trace authorization on page 493
set trace dot1x on page 493
set trace sm on page 494
show trace on page 495
clear log trace
Deletes the log messages stored in the trace buffer.
Syntax: clear log trace
Defaults: None.
Access: Enabled.
Examples: To delete the trace log, type the following command:
DWS-1008# clear log trace
See Also:
• set log
• show log buffer