Filter
Top Products
D-Link DWS-1008 CLI Manual 314
set dap auto persistent
Converts a temporary AP configuration created by the AP configuration profile into a persistent
AP configuration on the DWS-1008.
Syntax: set dap auto persistent [dap-num | all]
dap-num
all
Defaults: None.
Access: Enabled.
Usage: To display the Distributed AP numbers assigned to Auto-APs, use the show dap status
auto command.
Examples: The following command converts the configuration of Auto-AP 10 into a permanent
configuration:
DWS-1008# set dap auto persistent 10
success: change accepted
See Also:
• set dap auto
• set dap auto mode
• set dap auto radiotype
Converts the configuration of the Distributed AP that has the specified
connection number into a permanent configuration.
Converts the configurations of all Auto-APs being managed by the switch
into permanent configurations.
set dap auto radiotype
Sets the radio type for single-AP radios that use the AP configuration profile.
Syntax: set dap auto [radiotype {11a | 11b| 11g}]
radiotype 11a | 11b | 11g
Radio type:
• 11g - 802.11a
• 11a - 802.11b
• 11g - 802.11g