Filter
Top Products
D-Link DWS-1008 CLI Manual 501
set snoop mode
Enables a snoop filter. A snoop filter does not take effect until you map it to an AP radio and
enable the filter.
Examples: set snoop {filter-name | all}
mode {enable [stop-after num-pkts] | disable}
{filter-name | all} Name of the snoop filter. Specify all to enable all snoop filters.
enable [stop-after num-pkts] Enables the snoop filter. The stop-after option disables the filter
after the specified number of packets match the filter. Without
the stop-after option, the filter operates until you disable it or
until the AP is restarted.
disable Disables the snoop filter.
Defaults: Snoop filters are disabled by default.
Access: Enabled.
Usage: The filter mode is not retained if you change the filter configuration or disable and reenable
the radio, or when the AP or the switch is restarted. You must reenable the filter to place it back
into effect.
Examples: The following command enables snoop filter snoop1, and configures the filter to stop
after 5000 packets match the filter:
DWS-1008# set snoop snoop1 mode enable stop-after 5000
success: filter ‘snoop1’ enabled
See Also:
• show snoop
• show snoop info
• show snoop map
• show snoop stats