Filter
Top Products
D-Link DWS-1008 CLI Manual 267
RF Detection Commands
MSS automatically performs RF detection scans on enabled and disabled radios to detect rogue access
points. A rogue access point is a BSSID (MAC address associated with an SSID) that does not belong
to a D-Link device and is not a member of the ignore list configured on the seed switch.
MSS can issue countermeasures against rogue devices to prevent clients from being able to use
them.
You can configure RF detection parameters on individual switches.
This chapter presents RF detection commands alphabetically. Use the following table to locate the
commands in this chapter based on their use.
Rogue Information show rfdetect clients on page 275
show rfdetect data on page 280
show rfdetect visible on page 283
show rfdetect counters on page 278
Countermeasures show rfdetect countermeasures on page 277
Permitted Vendor List set rfdetect vendor-list on page 274
show rfdetect vendor-list on page 282
clear rfdetect vendor-list on page 269
Permitted SSID List set rfdetect ssid-list on page 273
show rfdetect ssid-list on page 282
clear rfdetect ssid-list on page 269
Client Black List set rfdetect black-list on page 270
show rfdetect black-list on page 285
Attack List set rfdetect attack-list on page 270
show rfdetect attack-list on page 274
clear rfdetect attack-list on page 268
Ignore List set rfdetect ignore on page 271
show rfdetect ignore on page 281
clear rfdetect ignore on page 268
AP Signatures set rfdetect signature on page 272
Log Messages set rfdetect log on page 272
DWS-to-Client RF Link test rflink on page 284