Filter
Top Products
D-Link DWS-1008 CLI Manual 411
Field Description
Radio 1 type
Radio 2 type
802.11 type and configuration state of the radio.
• The configure succeed state indicates that the AP has received configuration
parameters for the radio and the radio is ready to accept client connections.
• 802.11b protect indicates that the 802.11b/g radio is sending messages to
802.11b devices, while sending 802.11g traffic at higher data rates, to inform
the 802.11b devices about the 802.11g traffic and reserve bandwidth for the
traffic.
Protection mode remains in effect until 60 seconds after the last 802.11b traffic
is detected by the 802.11b/g radio.
• Sweep Mode indicates that a disabled radio is nonetheless participating in
rogue detection scans. Even though this message appears only for disabled
radios, all radios, enabled or disabled, participate in rogue detection.
• Countermeasures Enabled indicates that the radio is sending countermeasures
packets to combat a rogue.
• Radar Scan indicates that the radio is performing the initial channel availability
check for Dynamic Frequency Selection (DFS). This state lasts during the first
60 seconds an 802.11a radio is on a new channel, during which time the radio
does not transmit. If the radio does not detect any radar on the channel, the
radio starts using the channel for data. If the radio does detect radar, the flag
changes to Radar Detected.
• Radar Detected indicates that DFS has detected radar on the channel. When
this occurs, the AP stops transmitting on the channel for 30 minutes.
If RF Auto-Tuning is enabled for channel assignment, the radio selects another
channel and performs the initial channel availability check on the new channel,
during which time the flag changes back to Radar Scan.
Note: Radar Scan and Radar Detected apply only to 802.11a radios, for country
codes that use DFS.
• The following information appears for external antennas:
• External antenna detected, configured as antenna-model—Indicates that an
external antenna has been detected, and lists the antenna model configured
on the radio. (MSSdoes not detect the specific model.
operational channel
The channel on which the radio is currently operating.
Note: If the channel number is followed by (Auto), the value was set by RF Auto-
Tuning.
operational power
The power level at which the radio is currently operating.
Note: If the power setting is followed by (Auto), the value was set by RF Auto-
Tuning.
base mac
Base MAC address of the radio.
bssid, ssid
SSIDs configured on the radio and their BSSIDs.
RFID Reports
Status of AeroScout asset tag support.
• Active—The AeroScout Engine has enabled the tag report mode on the AP.
• Inactive—The AeroScout Engine has not enabled, or has disabled, the tag
report mode on the AP.
Note: This field is displayed only if the rfid-mode option is enabled on the radio
profile that manages the radio.