Filter
Top Products
D-Link DWS-1008 CLI Manual 281
The table below describes the fields in this display.
Field Description
BSSID MAC address of the SSID used by the detected device.
Vendor Company that manufactures or sells the rogue device.
Type
Classification of the rogue device:
• rogue—Wireless device that is not supposed to be on the network. The device has an
entry in a switch’s FDB and is therefore on the network.
• intfr—Wireless device that is not part of your network but is not a rogue. The device
does not have an entry in a switch’s FDB and is not actually on the network, but might be
causing RF interference with AP radios.
• known—Device that is a legitimate member of the network.
Port/Radio/Channel
Port number, radio number, and channel number of the radio that detected the rogue. For
a Distributed AP, the connection number is labeled dap. (This stands for distributed ap.)
Flags
Classification and encryption information for the rogue:
• The i, a, or u flag indicates the classification.
• The other flags indicate the encryption used by the rogue.
For flag definitions, see the key in the command output.
RSSI
Received signal strength indication (RSSI)—the strength of the RF signal detected by
the AP radio, in decibels referred to 1 milliwatt (dBm).
Age Number of seconds since an AP radio last detected 802.11 packets from the device.
See Also:
• show rfdetect visible
show rfdetect ignore
Displays the BSSIDs of third-party devices that MSS ignores during RF scans. MSS does not
generate log messages or traps for the devices in the ignore list.
Syntax: show rfdetect ignore
Defaults: None.
Access: Enabled.
Examples: The following example displays the list of ignored devices:
DWS-1008# show rfdetect ignore
Total number of entries: 2
Ignore MAC
-----------------
aa:bb:cc:11:22:33
aa:bb:cc:44:55:66
See Also:
• clear rfdetect ignore
• set rfdetect ignore