Filter
Top Products
D-Link DWS-1008 CLI Manual 112
set snmp security
Sets the minimum level of security MSS requires for SNMP message exchanges.
Syntax: set snmp security {unsecured | authenticated | encrypted |
auth-req-unsec-notify}
unsecured SNMP message exchanges are not secure. This is the only value
supported for SNMPv1 and SNMPv2c.
authenticated SNMP message exchanges are authenticated but are not
encrypted.
encrypted SNMP message exchanges are authenticated and encrypted.
auth-req-unsecnotify SNMP message exchanges are authenticated but are not
encrypted, and notifications are neither authenticated nor
encrypted.
Defaults: By default, MSS allows nonsecure (unsecured) SNMP message exchanges.
Access: Enabled.
Usage: SNMPv1 and SNMPv2c do not support authentication or encryption. If you plan to use
SNMPv1 or SNMPv2c, leave the minimum level of SNMP security set to unsecured.
Examples: The following command sets the minimum level of SNMP security allowed to
authentication and encryption:
DWS-1008# set snmp security encrypted
success: change accepted.
See Also:
• set ip snmp server
• set snmp community
• set snmp notify target
• set snmp notify profile
• set snmp protocol
• set snmp usm
• show snmp status