Filter
Top Products
D-Link DWS-1008 CLI Manual 333
AP can establish a management session with the DWS-1008 switch only if its fingerprint has
been confirmed by you in MSS.
A change to DWL-8220AP security support does not affect management sessions that are already
established. To apply the new setting to an DWL-8220AP, restart the DWL-8220AP.
Examples: The following command configures a DWS-1008 to require Distributed APs to have
encryption keys:
DWS-1008# set dap security require
success: change accepted.
See Also:
• set dap fingerprint
• show {ap | dap} config
• show {ap | dap} status
set {ap | dap} upgrade-firmware
Disables or reenables automatic upgrade of a DWL-8220AP access point’s boot firmware.
Syntax: set {ap port-list | dap {dap-num | auto}} upgrade-firmware {enable | disable}
ap port-list
dap dap-num
dap auto
enable
disable
Defaults: Automatic firmware upgrades of DWL-8220AP access points are enabled by default.
Access: Enabled.
Usage: When the feature is enabled on a DWS-1008 port, a DWL-8220AP access point connected
to that port upgrades its boot firmware to the latest version stored on the switch while booting.
Examples The following command disables automatic firmware upgrades on the DWL-8220AP
access point connected to port 2:
DWS-1008# set ap 2 upgrade-firmware disable
List of ports connected to the DWL-8220AP access point(s) on which to
allow automatic firmware upgrades.
Number of a Distributed AP on which to allow automatic firmware
upgrades.
Configures firmware upgrades for the AP configuration profile.
Enables automatic firmware upgrades.
Disables automatic firmware upgrades.