Filter
Top Products
D-Link DWS-1008 CLI Manual 458
set igmp querier
Enables or disables the IGMP pseudo-querier on a DWS-1008 switch, on one VLAN or all
VLANs.
Syntax: set igmp querier {enable | disable} [vlan vlan-id]
enable Enables the pseudo-querier.
disable Disables the pseudo-querier.
vlan vlan-id VLAN name or number. If you do not specify a VLAN, the pseudo-querier is
enabled or disabled on all VLANs.
Defaults: The pseudo-querier is disabled on all VLANs by default.
Access: Enabled.
Usage: D-Link recommends that you use the pseudo-querier only when the VLAN contains local
multicast traffic sources and no multicast router is servicing the subnet.
Examples: The following example enables the pseudo-querier on the orange VLAN:
DWS-1008# set igmp querier enable vlan orange
success: change accepted.
See Also:
• show igmp querier
set igmp receiver
Adds or removes a network port in the list of ports on which a switch forwards traffic to multicast
receivers. Static multicast receiver ports are immediately added to or removed from the list of
receiver ports and do not age out.
Syntax: set igmp receiver port port-list {enable | disable}
port port-list Network port list. MSS adds the specified ports to the list of static multicast
receiver ports.
enable Adds the port to the list of static multicast receiver ports.
disable Removes the port from the list of static multicast receiver ports.
Defaults: By default, no ports are static multicast receiver ports.
Access: Enabled.