Filter
Top Products
D-Link DWS-1008 CLI Manual 47
Defaults: None
Access: Enabled.
Usage: To simplify configuration and avoid confusion between a port’s number and its name,
D-Link recommends that you do not use numbers as port names.
Examples: The following command sets the name of port 4 to adminpool:
DWS-1008# set port 4 name adminpool
success: change accepted.
See Also:
• clear port name
set port negotiation
Disables or reenables autonegotiation on gigabit Ethernet or 10/100 Ethernet ports.
Syntax: set port negotiation port-list {enable | disable}
port-list
enable
disable
Defaults: Autonegotiation is enabled on all Ethernet ports by default.
Access: Enabled.
Usage: The gigabit Ethernet ports operate at 1000 Mbps only. They do not change speed to
match 10-Mbps or 100-Mbps links.
The DWS-1008 Ethernet ports support half-duplex and full-duplex operation.
D-Link recommends that you do not configure the mode of a DWS-1008 port so that one side
of the link is set to autonegotiation while the other side is set to full-duplex. Although MSS
allows this configuration, it can result in slow throughput on the link. The slow throughput occurs
because the side that is configured for autonegotiation falls back to half-duplex.
List of physical ports. MSS disables or reenablesautonegotiation on all the
specified ports.
Enables autonegotiation on the specified ports.
Disables autonegotiation on the specified ports.